Loxeal Engineering Adhesives and Sealants

FOR ANAEROBIC ADHESIVES

Cleans, degreases parts and speeds up the setting time of anaerobic adhesives and sealants. Curing effect is obtained in 20 - 120 seconds depending from type of adhesive, gap between parts and room temperature. The Activator is applied on one surface and let to dry for a few seconds.

Solvent free Activator to speed up the setting time of anaerobic adhesives and sealants. Curing effect is obtained in 20 - 120 seconds depending from type of adhesive, gap between parts and room temperature. Apply the Activator to one surface and the anaerobic Adhesive to the other one.

To be used with Adhesive 33-00. Apply the Adhesive on one part and the Activator on the other. The suggested ratio Adhesive: Activator is approx. 5:1 w/w, but may be varied without large differences in the results. Assemble parts and wait few minutes to achieve fixing. No mixing required. With Activators 20 and 21 fixing is obtained in about 1 minute. Activator 22 develops the bonding effect in about 5 minutes.

Loxeal Cleaner 10 is a non-CFC solvent based formulation for clianing and degreasing of surfaces to be bonded or sealed with Loxeal adhesives or sealants.

FOR CYANACRYLATE ADHESIVES

Solvent based treatment which allows bonding of polyolefin (polyethylene, polypropylene), thermoplastic rubbers, EPDM, PTFE, silicones and other difficult to bond materials. Polyolefin Primer is recommended for use with Loxeal 34 Instant Adhesive.

Cleans, degreases parts and speeds up the setting time of cyanoacrylate adhesives. Curing effect is obtained in 1 - 4 seconds depending from type of adhesive, gap between parts and surfaces composition. The Activator is applied on one surface and let to dry for a few seconds.